The concept: Plug-and-Go

Instalation of i-soamp amplifiers and Auxgate® multimedia extensions

i-sotec Plug-and-Go stands for sound tuning without drilling or sawing. With an i-soamp connected to your car audio system, you get 100 percent more music in 20 minutes. Neither special tools nor technical knowledge are needed.
On this page you can see how easy it is to connect an i-soamp to a car radio with standard ISO connectors thanks to i-sotec's Plug-and-Go concept.

1. Get the radio out.

First, you remove the car radio from it's slot. Usually, this is done by inserting two pins, usually supplied with the radio, in the corresponding holes, so the radio can be pulled out easily. If in doubt, seee your radio's manual for details.

2. Disconnect and re-connect the cables.

The car radio is connected to the car's power supply and the loudspeakers via ISO-connectors at the backside. Disconnect them, so you can simply plug the i-soamp cable harness between.

All plugs and receptacles at the i-soamp cable harness exactly fit their counterparts at the radio and the car's cable harness, safe of mixing up or voltage reversal. For an overview of the connection principle, click here.

If your car and/or your factory radio has manufacturer-specific connectors instead of ISO, you can still easily connect an i-soamp, thanks to i-sotec offering adapters for more than 500 car types.

3. Hide the amplifier

As soon as the radio is put back in it's slot, you only have to place the i-soamp at a safe, not too heat-sensitive place in the car - e.g. beneath the passenger seat - choose one of the three operation modes (four channel ampplifiers) and connect the (optional) subwoofer with just one cable.

4. Place the subwoofer

i-sotec subwooofers find their place in any car. No matter if you choose the universal wedge housing CompactSub (as pictured), the spare wheel subwoofer i-sosub or one of our custom-tailored car-specific subwoofers - no space is wasted; the boot stays usuable.

3. Connect the subwoofer

One Cable - as you know it, with a mix-up- and voltage-reversal-safe connector - is all you need to connect an i-sotec subwoofer to the i-soamp.